Posts

Chosen Solution Didn’t know you needed a special Garage ready refrigerator. It died a few days ago. Not 9 months old. Is it fixable or do I need to purchase a new refrigerator. My old one lasted for 15 years….but now I know. Hi, What is the make and model number of the refrigerator? Most fridges are repairable, unless there is a problem with the sealed system tubing that is encased in the insulation in the refrigerator....

Chosen Solution Hello, my iPhone 5s shows searching after booting up and after 30 seconds it says no service or sometimes Cellular update failed error. I checked the about page in Settings-General and it does not show modem firmware but it shows IMEI. When I go to the phone app and dial *#06# just nothing happens. I remembered that my phone dropped in water like 1 month ago and nothing happened, but after 3 weeks I saw this error....

Chosen Solution I no longer get sound as it stating I have no audio output device installed. I’ve performed several refreshes of the complete system without any success The bios has been flashed and still no joy. Any ideas. Also check control center > sound devices and make sure its outputting to the correct device. After updates windows tend to change sound settings. If that doesnt work contact hp and ask for driver help

Chosen Solution My PSVita will not take a charge or power on I bought it from a pawn shop a while back and it would not do anything and they would not take it back what might be the problem and how would I fix it. @fatedengram this can be an issue with the charger, the charging port and/or the battery. Use a multimeter and check your charger to make sure that it has the proper voltage output (5V)....

Chosen Solution I have my old MacBook Pro that has 10.6.4 Snow Leopard just if I want to mess around + to run old software, but now I also need it to host a “server” (if you could call it that) - so I need 10.13 High Sierra on it. Problem is, I don’t want to go through those 8 hours of installing 10.6 on this computer again + I may need to use that older software again, so I want to have one partition be 10....

Chosen Solution The phone still works. I was able to tell by hearing the sound whenever I charge it. I was also able to tell that the phone still works by calling it with another phone since the phone with the black screen was ringing. I was also able to tell that it was still working by feeling the vibrations whenever I enter a number on the lock screen (When it asks for the password of the phone)....

Chosen Solution Poor Signal Bluetooth, Wi-Fi and GPS on iPhone6. I do not know how to fix it. Can u give me some advice? replace this the wifi and bluetooth antenna and follow this steps you should see this part behind the board on the left side iPhone 6 Logic Board Replacement

Chosen Solution Due to over charging the port that I would attach the USB to is very loose. At first it may seem like it is but the littlest movement can dislodge it and it won’t charge. Can this be fixed or replaced? Try a different USB cable if you haven’t already, I’ve found that some cables stop working after a few months. There is no way to replace just the USB port as it is integrated onto the motherboard....

Chosen Solution Hi, just replaced the display assembly on my mac and currently have a black screen. I think i may have damaged the thin piece of foil on top of the inverter but i am unsure if this would cause the screen to be black. The replacement display is brand new and i am only replacing it because the previous screen got smashed. The screen has flashed once or twice but apart from that it has been black and the apple logo on the back unlit....

Chosen Solution The screen on my iMac has stopped working and I do not get an Apple logo unless I start it up in safe mode. If I do it has diagonal pixellated patterns which make it impossible to see anything. In normal start up mode there is just a strange pattern and the pointer becomes some lines of text. I am told that it must be the logic board. Is it possible to get a replacement?...

Chosen Solution Dropped my Apple Watch and the screen popped out. It separated below the gasket and touch sensor as the screen an touch are still working even while separated from the phone. Anyone else experienced this? I’m stumped. This happens more often than you would think. Unfortunately the adhesive is the only thing that holds those screens in place and they degrade over time. This happens quicker if you are in a warm environment often, a sauna, in direct sun, or if it’s getting wet often....

Chosen Solution I have a Blade 350 QX3 that I am not having luck reassembling the antenna to the GPS. The rest is all disassembled so I guess I would need you to put it all back correctly. Michael 415-717-1220 Hello. Are you still needing help. I have disassembled and reassembled many 350QX’S and would be happy to help.

Chosen Solution I need to clean the trackpad and keyboard so I ordered the Pentalobe P5 and it opened the back but inside to get to the trackpad and keyboard you need an even smaller screwdriver, do you carry that screwdriver ? Theses tools should do it for you Tools Buy these tools * P5 Pentalobe Screwdriver Retina MacBook Pro and AirPhillips #00 ScrewdriverSpudgerT5 Torx Screwdriverhttps://www.ifixit.com/Guide/MacBook+Air…

Chosen Solution Anyone have any trouble with opening the new phones? I have stripped out 3 separate bits on a brand new XS phone. I will get in…it is just an annoyance right now. I have been doing this for several years now, so this isn’t user error…just checking to see if anyone else has had the same issue as me. The pentalobe screws have not changed, they still are taken out with a P2 pentalobe screwdriver....

Chosen Solution Hi everyone, I have a Nexus 7 Model 2012. The device was not in use for the last 6 months. Today after 3 hours of charging, the screen stays blank/black (after pressing power button), moreover when i connect the tablet to my computer i can hear the “connecting sound” but still no visual (not even the Google logo) Please help me to solve this issue/problem. Thanks Have you ever root you phone?...

Chosen Solution Hi I have a Honda accord 1997 automatic 4 cylinder. Last night I was driving it then I stopped the engine and wnt to start it again and now it won’t start unless I jump start it. I just replaced the battery about a month ago and the alternator about 2 months ago so I doubt its either of those and I just replace the battery fuse today. Any suggestions?...

Chosen Solution My samsung wf45k6500a washing machine recently stopped turning on altogether. It’s not the wall outlet, I plugged my vacuum into that. I checked continuity from the power cord, into the main control board, and up to the front user interface( I don’t know what this is actually called. It’s where the dial and buttons are located on the front), and that was not a problem. Could it be the blown fuse in the circuit or potentially a broken front interface?...

Chosen Solution Battery is good checked all the cables and fuses are good still nothing First, turn on headlamps. If they’re bright, and don’t dim when the key is turned, the battery is o.k. listen for a click. if you hear any click, it’s probably the starter. No click - try turning the key with the shifter in “N” Nothing - back to Park. At this point, it could be anything; ignition switch, neutral safety switch, open wiring, etc....

Chosen Solution My 3DS was not reading games so I took it apart and replaced the game cartrige reader, that went fine but now it would not power up. While the back case was off, I took the battery and pushed it in to the 3 pins (where the ribbon cable, motherboard is etc) and it started charging and powering up, but when I put in the battery like its supposed to its not charging....

Chosen Solution I actually have an xp-640 but it wasn’t on the list. I set it up thru a desktop, but also want to use a chromebook with it. it prints fine from the chromebook, but despite all the settings looking correct it will not scan to the chromebook, only the desktop. have tried getting an answer from epson but still waiting! I can’t get into epson connect because it says password is wrong but i never get the email from them to reset the pw....